Most Popular Articles

Things You Need To Know To Generate Your Own Power PDF   E-mail
Written by Mike Allen   
Friday, 03 September 2010
How much to install solar water heater? Want to solar heat your water but don't want to spend thousands of dollars to do it? Are you unsure whether you can use a renewable resource to run your whole home.? For the home handyman there are a couple of guidelines that can be used to ensure that they put together a solar power source for their home if they want to.
by MikeAllen


Does it cost a lot to star heating your water with a natural resource? Do you want to use green technology to provide you with hot water, but don't want to blow the budget? Are you unsure whether you can use a renewable resource to run your whole home.? What follows below might take some of the mystery out of undertaking this project on your own without the help of a professional.

You can use the sun to generate the heat that is needed to allow you to have ample supplies of hot water in your home.

Your consumption of fossil fuel will be greatly diminished by using solar energy for electricity as well, and may even disappear altogether and keep in mind that many energy providers and government agencies have rebate plans for people who install solar power as well so Oregon solar panels have the potential to decrease your electric bill.

Putting in the solar panels can be done following some simple things. For every individual in your home you need to have about thirty pounds of hot water available daily.

A greendiyenergy expert suggests that to figure out how much thermal panel you will need for the roof or where you are putting the system that you will need approximately 20 square feet for two residents and for more people add around 8 square feet each, although you may want to make it up to 14 feet if you live in a particularly cold region.

Investigate what spots on your home get the needed amount of sunlight to power your system. For a majority they will find the roof of their house to be the most convenient location due to the ease of mounting the panels, the amount of sunlight and the ease of installing the other necessary equipment. It is a good idea to layout exactly where everything goes to ensure that it can be securely mounted to the home. After you have attached the mounting hardware to the roof, go back and use some type of compound to cover any holes that are made by the screws. Use the proper hardware to attach the panels to the mounting brackets so they will not be damaged in any type of storm. Don't try to rig your equipment to make it work, but rather have the proper hardware on hand to install the pipes that are attached to the panels. Do the job right the first time to make sure that you are not going to have issues with any water leaking into your home. Connect the piping on the roof to the supply that you have inside the house with copper pipes. Check to make sure that your joints are watertight. Refill heater with water and flip the gas back on. Those are the basic steps although, for most people this might be more of a job for a professional to undertake, it can be done by the homeowner who does his homework and checks out other people's greendiyenergy review to find out what pitfalls and mistakes should be avoided.

A person can lower their dependency on the big utilities if they start to use the power of the sun. This should not be forgotten if you want to build your own solar energy system. Anyone with some basic skills will find that this is a project that can be completed in a relatively short time. It is important to understand that a person should seek out the guidance of either a professional or well written instructions before do ing this on their own. There are a few things that a person should be aware of. Make sure the panels that you buy are high quality and you have the right hardware to go with them. Use a stud finder to find the rafters and align mounts. Use the proper equipment to ensure that all of the panels are straight and aligned. Install solar panels and connect them into an array. Run the conduit to connect the panels to the inverter.

These type of systems do not require a lot of maintenance to keep them running. All that has to be done is to put the money that is saved to good use. It is great to know that your utility bills are more under your control.

The Article Author:

 
< Prev   Next >
Share it!
Add to: Del.ico.us Add to: Reddit Add to: Digg Add to: StumbleUpon Add to: Furl Add to: Yahoo Add to: Blogmarks Add to: Technorati Add to: Google Add to: Blinklist